— Previous article
不思議の国のアリスを読んでいる間に､もう紹介されたウサギが「が」をまだ使っていることに気づきました。日本語で､もう知っているトピックに「は」を使いますね。でも、日本語の小説は､キャラクターをもう紹介したら､まだ「が」をよく使いますか。I’m assuming that the particle doesn’t have the purpose of introducing new info here, and it also isn’t part of a dependent clause. ありがとうございます♪
Next article —
9 comments
This seems like a post about shopping, maybe your question is solved by [the wiki page](https://www.reddit.com/r/japanlife/wiki/shopping)?
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/japanlife) if you have any questions or concerns.*
I’ve never used them, but DMM has a 3d printing service:
https://make.dmm.com/print/
FabCafe in Shibuya.
@op; can you please write an update if you decide to use any service? I’m interested to do it myself.
Looking for resin or plastic?
I live in Tokyo and I have a printer! I’ve done different prints for people before. I can do it for cheap no problem!
I have a PLA 3D printer and tons of material. DIY that shit at home. I’ll sell my kit for a good price. 🙂
I use https://jlcpcb.com/3d-printing. It ships in from overseas so it takes a week or so but the prices are reasonable and they’re very good quality for small parts.
JLCPCB is an abroad service, but the shipping fee seems reasonable and they offer many types of material. Below is a very specific example of a rather complicated print (think 10+ hours at nice small layer height)
> Black pills are around 4 $ each on Ali, printing the 4 pieces of the case was 18$, pcb parts(you get enough for 2.5 cases…) was 19$, diodes and tres ports a few dollars.
>
> So maybe around 50$ including shipping, excluding switches and keycaps
>
> Still diodes, because you really don’t want to swap soldering diodes with soldering more wires…
https://old.reddit.com/r/ErgoMechKeyboards/comments/vhmjmn/resin_blackpill_skeletyl/idaudvc/